Publicidad
Idiomas disponibles
Idiomas disponibles
AC24NE
Instalation:
1) Open the cover and connect wires.
2) Mounted the receiver and transmitter on the proper position.
3) Ensure there are no obstacles between receiver and transmitter.
For optimal e ciency, the receiver and transmitter should be properly aligned.
4) Power-up the photocells and make sure the LED light on receiver and transmitter are ON.
Step 1
Get Started
Note:
A) Transmitter memorizing must be done rst before system learning.
B) CHECKING THE Gate MOVEMENTS
1) Release the gearmotor with the release key and move the gate to the middle so that it is free to move in both opening
and closing directions; then lock the gearmotor.
rmateur
2) Perform the gate opening and closing several times and make sure the gates touches the limit switch at least 2~3 cm
before the mechanical stop.
Step 1: Remote Memorizing
Memorizing
Press button RF-Learn on the control board (Figure 1) as many times as the number corresponding to the desired
command, according to the following table, Within 10s, press the desired button on the remote that you want it to be
memorized ( gure 1)
(Figure 1)
Pantalla LED
LED2 Push button or
ton-poussoir
électeur à clé
key selector
LED4 Photocell 1
cellule 1
LED3 Photocell 2
cellule 2
LED2
LED4 LED3
mt2 GND Lmt3 Lmt4 GND
DKeySKey
GND
Ph1
PhVcc
4 15 16 17 18
19 20 21 22 23 24 25 26
Step 2
(UP)
(SET)
(DOWN)
(RF-LEARN)
11
GND
Ph2
PhVcc
Step 3
Times for
pressing
Command
RF-Learn
1 vez
Open - Stop - Close circle
2 veces
Pedestrian mode
(Figure 2)
Opening your life
Step 4
Command
Message code
LED display "OSC"
LED display "PED"
1 13
Publicidad
