Operating Position; Cutting With Trimmer Head - Maruyama BT23L Manual Del Propietário

CAUTION
• Read the Safety instructions on page US-6
concerning proper use of the String Trimmer.

Operating Position

Before using the Trimmer, check the following:
1. Make sure the Holding Tool (3.5mm Pin) has been
removed from the gearcase and boss adapter
before you start the engine.
2. The Trimmer must be on the operator's right side.
3. The operator's right hand should be holding the
shaft grip, with his or her fingers on the throttle
trigger. The right arm should be slightly bent.
4. The left hand should be holding the loop handle
with the fingers and thumb fully enclosed around
t h e g r i p . T h e l e f t a r m m a y b e e x t e n d e d .
Reposition the loop handle up or down the
driveshaft if necessary for a comfortable position.
5. The trimmer weight should be evenly distributed
between the arms. The cutting attachment should
be near and parallel to the ground.
6. Accelerate and hold the engine at cutting speed
before entering the material to be cut.
7. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
8. Stop the engine when moving between work sites.
• Always wear gloves and protective clothing
when operating the String Trimmer.
• If the trimmer head becomes jammed, stop the
engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
• Never use a String Trimmer that has chipped,
cracked or broken trimmer head.

Cutting with Trimmer Head

• The tip of the line does the cutting. The line should
stay extended while cutting.
Three inchs (7,6cm)
Three inchs (7,6cm)
above Ground
above Ground
Three inchs (7,6cm)
above Ground
• Do not force the line into the material. Forcing the
line will cause it to slap against the material,
increasing line usage and causing poor cutting
results.
INCORRECT
− US-14 −
CAUTION
CORRECT
CORRECT
CORRECT
INCORRECT
INCORRECT