Bosch 25618 Instrucciones De Funcionamiento Y Seguridad página 13

BM 2610034434 09-15_24618 25618 IWH181 9/8/15 9:27 AM Page 13
housing counter-clockwise with a coin or
screwdriver and remove cap (Fig. 8).
Lift out the brushes; note which way they face,
so that the brushes can be returned to their
original position. New brushes can also be
inserted turned 180º. Clean the brush holder
openings with com pressed air or a clean cloth
and replace the brushes and brush covers.
After replacing brushes the tool should be run
at no-load and run it freely at full speed for 2
minutes before using the tool. This will allow
the brushes to "seat" properly and will give
you more hours of life from each set of
brushes.
Cleaning
To avoid accidents, always
disconnect the tool and/or
WARNING
charger from the power supply before
cleaning. The tool may be cleaned most
effectively with com pressed dry air. Always
wear safety goggles when cleaning tools
with compressed air.
(* = standard equipment)
(** = optional accessories)
Only genuine Bosch replacement brushes
specially designed for your tool should be
used.
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six months.
Only a genuine Bosch replacement motor
specially designed for your tool should be
used.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
plastic parts. Some of these are: gasoline, CAUTION
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
Accessories
* Screwdriver bit
* Carrying case
-13-
D.C. MOTORS
Certain cleaning agents
and solvents damage