Orbegozo CP 72120 Manual De Instrucciones página 12

CP 72120
INSTALL MOUNTING BRACKET
1. Mount the mounting bracket onto outlet
box by the 2 screws. Spring washers and
flat washers.
BLADE ATTACHMENT
Note : Before installing the fan, you need to attach the blades onto the motor.
1. Insert the blade through the slot on the center brand. Alian holes and fasten the blade to
the motor with provided screws. Repeat this procedure for remaining blades. After all the
blades are securely fastened to the motor, push the top housing down on hte motor and
fasten the top fan housing with screws.
2. Put the light base onto the connecting board, then revolve it clockwise and fastern it by
screws.
WARNING : Make sure all screws are tightened securely. Use the lock washers provided.
2. Hang the ball joint and the fan onto the
bracket. Make sure the guied pin of
bracket is fitted into slot of ball joint.
5. Connect wires from supply and the
bracket to the wiring terminals as follow :
Brown wire « L »
Blue wire « N »
Green/yellow stripes wire « Θ ».
3. Insert the remote control receiver
between the bracket
downrod. And the sensor as shown.
6. Fix conopy onto the bracket by
tightening the screws.
and the
12