Publicidad
Idiomas disponibles
Idiomas disponibles
Verificación del agua entrante
Presione el botón Bloquear , encienda nuevamente la alimentación y entonces
verifique la válvula de entrada.
Abra el agua fría y caliente durante 1 minuto, se verá "1" en el tiempo de
lavado y brillará, apague cualquier exportación, el proceso habrá finalizado
cuando se escuche la señal sonora seis veces. En todo el proyecto, sólo el
botón "Iniciar/Pausar" puede cumplir una función.
Endurance test appliance
Press pause/start key and power on, Computer board cycles according to the
selected program.
43
All manuals and user guides at all-guides.com
Quick start
1. Instal the washing machine
2. Load the laundry
3. Measure out the detergent
4. Close the machine door
5. Put down (hang up) the drain pipe
6. Turn on the water tap
7. Plug the power supply
8. Select the desired programme
9. Press the start/pause key
Programme selection
1. Select the program than select the proper water level or attached functions
2. To press the start/pause key.
The wash stops
• When the wash stops, the buzzer will buzz continuously for 6 times and then
the power will be automatically cut off.Be sure to position the program knob
to cycle OFF.
• Turn off the water tap.
• Although the power can be cut off automatically, the power plug must be pull
out as well for the safety.
Attention
Close the lid of the door before machine runs, otherwise, it will automatically
stop working during all the process and send out abnormal warning.
The washer will not work when the filled water does not reach the set water
level.
In the spin process is locked door, the door cover can not be opened.
If you need to open the door cover, press the (Start / Pause) key, the drum will
stop rotating, unlock the door cover.
44
Publicidad
