Danby Designer DWC458BLS Manual Del Propietário página 7

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging in to
avoid damage to internal components.
1. Remove the screw covers and the screws.
Remove the hinge cover.
2. Remove the upper hinge and the door. Remove
the screw hole covers from the top left side of
the cabinet and move them to the screw holes on
the right side of the cabinet. Remove the hinge
hole cover from the top left side of the door and
move it to the hinge hole on the top right side of
the door.
3. Remove the solid foot from the left side of the
cabinet and remove the lower hinge from
the right side of the cabinet. Exchange their
positions and reinstall.
4. Replace the door on the cabinet. Install the
upper hinge and the hinge cover.
Note: Before tightening the screws on the upper
hinge, ensure that the top of the door is level with
the top of the cabinet, that the actuator on the
bottom of the door is making contact with the switch
on the cabinet and that the rubber gasket is making
a good seal with the cabinet all the way around.
1. Screw Cover
2. Screw
3. Hinge Cover
4. Upper Hinge
5. Lower Hinge
6. Solid Foot
1
2
3
6
4
6
1
2
3
2
4
5
2