Mounting Of Handle; Approved Combination Of Cutting Tool, Protector, Handle And Harness - Makita EM2650UH Manual De Instrucciones

MOUNTING OF HANDLE

CAUTION: Before doing any work on the equipment, always stop the engine
and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the engine only after having assembled it completely.
For machines with bike handle models
– Loosen knob (1).
– Place handle (4) between handle clamp (2) and handle holder (3).
– Adjust handle (4) to an angle that provides a comfortable working position
and then secure by firmly hand-tightening knob (1).
CAUTION: Do not forget to mount spring (5).
For machines with loop handle
– Fix the loop handle on the shaft as shown.
– To keep a proper distance between the grips, set the loop handle ahead of
the arrows.

APPROVED COMBINATION OF CUTTING TOOL, PROTECTOR, HANDLE AND HARNESS

WARNING: Always use the tool with the approved combination of the safety equipments.
Otherwise contact with a cutting tool may cause serious injury.
Use of nylon cutting head (EM2650UH, EM2650LH, EM2652LHN)
Nylon cutting head
Use of metal blade (EM2650UH, optional accessory for EM2650LH, EM2652LHN)
Metal blade
(Clamp
washer,
cup, and
nut are
necessary)
6
6
Protector
(With protector extension)
Protector
(Without protector extension)
7
7
Handle
8
(With or without barrier bar)
8
9
9
Handle
(With barrier bar)
10
10
9
（1）
（2）
（4）
（3）
（5）
Engine
Engine
Harness
(With or without shoulder strap)
Harness