Avintage AVI61XDZA Manual De Utilización página 44

LIGHT
To control the inner light turn on/off.
« UP »
Used to increase (warm) the set temperature by 1°C/1°F.
« DOWN »
Used to decrease (cool) the set temperature by 1°C/1°F.
SELECTOR
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, press the button
Temperature selection
The wine cooler has two temperature zones. The temperature settings of LOWER ZONE and UPPER
ZONE are adjustable with the range 5-22ºC/40-72ºF. It is recommended to set the LOWER ZONE to 12-
22ºC / 55-72ºF which is ideal for storing white and red wines and the UPPER ZONE to 5-12ºC / 40-55ºF
which is ideal for storing sparkling and white wines.
NOTE: the temperature set for the lower zone must always be the same or higher than that in the
upper zone. For optimal performance, the set temperature of the two zones should differ by at
least 4°C.
 You can touch UP and DOWN mark to set the internal temperature for each zone. The degrees
indicators will appear in the display window marked
 When the unit is plugged in for the first time, the LED readouts will show the original temperature sets
previously (the preset temperature at the factory for upper zone is 10ºC / 50ºF and for lower zone is
16ºC / 60ºF).
 Touch the UP and DOWN mark once of each compartment to set the desired temperature.
 The temperature will increase 1°C or 1ºF if you touch the UP mark once, or the temperature will
decrease 1°C or 1ºF if you touch the DOWN mark once.
Temperature display
To view the "set" temperature in either zone at any time, touch the UP or DOWN mark of each
compartment, the "set" temperature will temporarily "flash" in the LED display for 5 seconds. Then the
display shows the current inner temperature again.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature shows on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to
wait 5 minutes before turning it on again. Otherwise, the wine cellar will not turn on.
ATTENTION: in normal operation, the display shows the temperature inside the cellar. When you
increase or decrease this temperature, the display will show the desired temperature. After a few
moments, the display will again show the temperature measured in the cellar.
The temperature display will flash if:
All manuals and user guides at all-guides.com
for 5 seconds.
for upper zone and for lower zone.
44