Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Auxiliary handle assembly
• For a safer operation use the auxiliary handle. Fit it
into any of the two mounting orifices. Use the one that
makes your job easier.
Start Up
The angle grinder is a manual power tool used to grind and cut steel, pipes, iron angles, brick, tile, stone and / or ceramic
pieces; to remove burr on metal surfaces, to level and make smooth welding lines. If the tool accessory is changed it can be
used to remove oxide and to polish metal surfaces and other materials.
Switch On
• Intermittent operation:
Connect the plug into the power outlet.
Press switch (A) to start the tool.
To stop, just release the switch.
• Continuous operation:
Connect the plug into the power outlet.
Press switch (A) and block it pressing the
continuous use button (B).
To stop, press and then release the switch.
How to correctly hold the tool
Always hold the tool with both hands. Hold the handle
with one hand and the other hand hold the auxiliary
handle. Be careful not to obstruct the ventilation slots.
• Grinding:
For better results hold the tool 15° to 30° regarding the
work piece. Move forwards to backwards applying light
pressure with a constant rhythm. This way the work piece
does not get too hot, will not discolor and there will not
be rough edges.
• Cutting:
Do not press, tilt or oscillate the tool. Work at a moderate
speed. The disc should always rotate counterclockwise
since there is a risk the tool shoots out uncontrolled.
To cut hard stones using a diamond cutting disc is
recommended.
Useful tips
• Work placing the disc in the right position to prevent damage.
• Press the work piece applying pressure lower than the tool's weight to prevent overload
damaging the motor and the disc.
• After installing a new disc allow it to run unloaded at least one minute. If vibration occurs
replace immediately.
• Avoid working on wood or soft metals like lead. These materials saturate the
CAUTION
disc very quickly making it useless.
A
B
7
ENGLISH
Publicidad
