Publicidad
Idiomas disponibles
Idiomas disponibles
CR 5017
SAFE POSITIONING
1. The heater must not be located immediately below a socket outlet
2. For your own safety and that of others: water and electricity are a dangerous combination! Do not use
this heater in the immediate surroundings of a bath, a shower or a swimming pool. Ensure that the
appliance cannot fall into water (bath wash basin, shower cubicle, etc.)
3. Please read also the safety information's before using.
4. Do not use the heater on extremely deep-pile carpets!
5. Do not use the heater in an upright position.
GENERAL DESCRIPTION
A. Air inlet grille
B. Air outlet grille
C. Selector switch
D. Thermostat knob
E. Control lamp
F. Tip- over switch
INSTRUCTIONS FOR USE
The selector switch and the thermostat knob enable you to select the following functions:
Selector switch:
Ο : OFF. Both the fan and the two heating elements are switched off
: "Cool air". Only the fan is switched on
I
: "Warm air for gradual heating-up. Medium power (750 W): the fan and one of the heating elements
are switched on.
II
: "Hot air" for quick heating-up. Full power (1500 W): the fan and the two heating elements are
switched on.
Thermostat knob:
With the thermostat knob you can set a constant room temperature. When the selector switch is set to
position I or position II the heater will automatically switch on as soon as the room temperature falls below
the set temperature.
As soon as the set temperature falls is reached, the switch will turn off.
Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise for a lower temperature
setting.
You may adjust the thermostat during use.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power
as soon as the heating elements become too hot.
13
Publicidad
