HEBU medical TITANIUM II Accu Instrucciones Para El Uso Y El Servicio página 20

EN
4. Screw the retaining screw in manually until hand tight.
5. Then tighten firmly using the fork wrench, as described above. The tightening torque is
6 - 7 Nm. Caution! Do not overtighten.
5 Operation
Switching on and off (see
Switching on: Push the switch forwards ( I )
Switching off: Push the switch back ( 0 )
Setting the oscillating
frequency (see
fig. 6
Select the oscillating frequency
when the motor is running. The
optimum oscillating
can be selected at the speed
gauge depending
properties of the plaster cast.
Oscillating
preselection using the electronic
speed gauge.
Lowest oscillating frequency
Highest oscillating frequency
20
fig. 4 Inserting the saw blade
)
fig. 5
)
frequency
on the
frequency
( 1 )
( 6 )
Oszillosäge TITANIUM II Accu
fig. 5 Switching on and off
fig. 6 Setting the oscillating frequency