Facom CL3.P10J Manual Original página 26

6. Keep the motor running when pulling the bit back out of a drilled hole. This will help prevent jamming.
7. With variable speed drills there is no need to center punch the point to be drilled. Use a slow speed to start the hole and accelerate by
squeezing the trigger harder when the hole is deep enough to drill without the bit skipping out.
Model
in
CL3.P10J 3/8
Model Free speed
rpm
CL3.P10J 1500
Operation as a Screwdriver (Fig. 2)
Select the desired speed/torque range using the dual range gear shifter (E) on the top of tool to match the speed and torque to the planned
operation. Insert the desired fastener accessory into the chuck (F) as you would any drill bit. Make a few practice runs in scrap or unseen
areas to determine the proper position of the clutch collar (D). Always start with lower torque settings, then advance to higher torque settings
to avoid damage to the workpiece or fastner.
BITS, METAL DRILLING
WOOD, FLAT BORING
HOLE SAWS
Maintenance
Your FACOM power tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of serious personal injury, place the forward/reverse button in the lock-off position or turn tool off and
disconnect battery pack before making any adjustments or removing/installing attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken
the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
Charger cleaning instructions
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
SPECIFICATIONS
Noise level
Pressure dB(A) Power dB(A)
k*
65 3 76
Weight Dimensions
kg mm
1.1 194 X 27 X 178
MAXIMUM RECOMMENDED CAPACITIES
Low Range (1)
1/4" (6.35 mm)
3/4" (19.05 mm)
3/4" (19.05 mm)
Vibrations level
m/s
2
k* k**
3 2.5 1.5
* k = measurement uncertainty in dB
** k = measurement uncertainty in m/s
26
2
High Range (2)
1/8" (3.18 mm)
1/2" (12.7 mm)
5/8" (15.88 mm)