Ingersoll Rand W5133 Especificaciones Del Producto página 5

Tool Model - W5133, W5133P, W5153, W5153P
Intelligent Power Control
Direction Mode
Forward
Reverse ALL
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Figure A —
Forward Torque
ft-lb (Nm)
10 (14)
8 (11)
6 (8)
4 (5)
2 (3)
0 (0)
Torque values shown in Figures A and B are approximate. Actual torque can be effected by the application and may vary from the values shown in
the graph.
Lubrication
Remove hammer case to apply lubrication on the anvil, impact mechanism assembly and gears. Apply grease evenly and sparingly. An excessive
accumulation of grease will result in sluggish operation. See drawing 48380273 and table below. Maintenance frequency is shown in a circular arrow
and defined as h=hours, d=days, and m=months of actual use.
(Dwg. 48380273)
Task Light
● Task Light is not user serviceable. Repair should only be carried out by an Ingersoll Rand authorized service center. User service may
result in electric shock, fire and or serious personal Injury.
● Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
● The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
47543664001_ed6
No Load Speed
Name
Hand-tight 0-800
Wrench-tight 0-1600
Mid-power 0-2100
Max-power 0-2100
Max-power 0-2100
Hand-tight
M6 M8 M10 M12 M14
Bolt Size
2
8h
1
8h
8h 1
Battery Model - BL2012
Max Torque
Shut-off
ft-lb (Nm)
Refer to Figure A
Refer to Figure B
230 (312)
280 (380)
295 (400)
Conforms to UL STD. 60745-1 & 60745-2-2.
Certified to CSA STD. C22.2 No. 60745-1 & 60745-2-2.
Figure B —
Forward Torque
ft-lb (Nm)
24 (33)
20 (27)
16 (22)
12 (16)
8 (11)
4 (5)
M8 M10 M12 M14
NOTICE
1
IR#
105
1
8h
CAUTION
Battery Model - BL2010,
BL2022
Max Torque
ft-lb (Nm)
Refer to Figure A
Refer to Figure B
240 (325)
340 (460)
365 (500)
Wrench-tight
Bolt Size
2
IR#
67
EN
4004004
EN-2