Publicidad
Idiomas disponibles
Idiomas disponibles
5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 10-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-
18°C.
1)
Light button
2)
Compartment selection button
3)
Temperature displays
4)
Button to increase temperature
5)
Button to decrease temperature
To switch the wine cellar on or off, press buttons 1 and 2 simultaneously. To change the temperature
reading unit, press the light button (1) for 5 seconds. The display will show the selected temperature
unit (°C or °F).
It is possible to adjust the temperature degree by degree; the temperature can be adjusted with the keys
or to
the right of the temperature display. In first, the desired compartment must be
selected by pressing button 2. The temperature range of this cellar is between 5°C and 18°C in each
zone.
To turn on or off the indoor light, press button 1.
However, it is advisable to turn off the light in normal use.
IMPORTANT: the temperature selected for the upper compartment must always be lower than
the temperature selected for lower compartment (2-compartment model).
Temperature display
The appliance designed to display setting temperature.To check cabinet's actual temperature, press
key 4 during 5 seconds, The value will turn back to setting temperature with another 5 seconds.
Note : The actual temperature is given for information only, it cannot be adjusted and depends on the
different cooling phases. A deviation of +/- 2°C from the selected temperature is normal.
The temperature display will flash if:
The temperature in the zone deviates by more than 5°C from the set temperature. The
-
temperature display flashing ensures that the temperature cannot rise or fall un-noticed and
impair the wine.
Note: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature shows on the display. Indeed, it is necessary to
wait a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous
temperature. To avoid excessive condensation when the ambient temperature is above 28°C, do not
lower the temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to
wait 5 minutes before turning it on again. Otherwise, the wine cellar will not turn on.
1
2
3
4
The light (LED) is suitable for storing wine.
5
50
Publicidad
