Descargar Imprimir esta página

Genius Car Alarm G34SI A Manual Del Usuario página 31

Publicidad

Idiomas disponibles

Idiomas disponibles

Genius Car Alarm
ARMING WITH ZONES' CANCELLATION
st
This system allows us to arm the alarm cancelling the shock sensor as the 1
zone and
nd
the shock sensor and doors' signal as the 2
zone. This is to avoid false alarm when the
shock sensor or the doors' switch is triggered.
1. Press button 1, then press button 3 within two seconds, the shock sensor is cancelled.
2. Press button 1, then press button 2 within 2 seconds, both the shock sensor and the
door's signal are cancelled.
DOORS' SIGNAL ARMING DELAY
This function allows us to arm the alarm even when the dome lights are on, because the
system will not recognize this signal for the programmed time, avoiding notices of open
door when the alarm is armed.
* See Programming Table-
Disarm of the system using the reset button
In case you lose the transmitter, damage it or the battery of the same dies,
you can disarm the system by pressing the reset button.
First, with the security system armed, open the driver's door and the siren will
start sounding.
Second, turn ON the ignition switch, before the 10 seconds press the reset
button the number of times assigned in the security code (1 as set by the
factory) the siren will continue to sound for 3 seconds and if the security code
is right the system will disarm.
PANIC
With this function, we can make the system to trigger intentionally to prevent or attract the
attention of people, in case of a theft or aggression attempt.
a. With the ignition in OFF,
- PANIC, BUTTON 3 FOR 3 SECONDS
b. The siren and the lights will trigger for 3 seconds.
c. Press button 1 or button 2 to stop PANIC, the system will remain armed.
d. With the ignition in ON. Activate PANIC.
By stopping PANIC, the system will remain armed without the ignition interrupter, but if the
ignition key is turned to OFF position, the IGNITION INTERRUPTER will be activated.
CAR FINDER
With this function we can make the system to send us signals with the siren and lights,
which will serve us to locate the vehicle, whenever we are in the transmission range
between the remote control and the vehicle.
a. When the alarm is armed,
- CAR FINDER, BUTTON 1 FOR 1 SECOND
b. The siren will chirp 10 times and the parking lights will flash 10 times.
c. Press button 1 or button 2 to stop the Car Finder.
DUAL-STAGE SHOCK SENSOR
If the vehicle receives a light impact, the siren will chirp and the lights will flash 5 times
each. If the vehicle receives a strong impact, the siren and the lights will trigger for 30
seconds.
*The sensitivity can be adjusted.
www.geniuscaralarm.com
31

Publicidad

loading

Este manual también es adecuado para:

3b serie