Remote control
Your kitchen hood is equipped with a remote control. It is shown in Figure 4a and
below:
Use remote control to control your kitchen hood. To do this, point the remote control
toward the front of the hood and select the appropriate function:
7-
Reduce fan speed
8-
Increase fan speed
9-
Turn lighting on/off
10-
Standby mode on/off
When purchased, battery is not included with the remote control. You can purchase
a single 3V CR2025 battery in any electronics store.
To replace the battery, slide out the tray (item 3 in the figure) on the bottom edge
of the remote control. Place the battery in the tray observing polarity. Slide the tray
back in.
Important! Ensure there are no obstacles between the remote control transmitter
and the sensor on the cooker hood. Fluorescent light can interfere with the remote
control operation.
Indication to clean the aluminium filters
If the
indication appears on the display, you need to clean the aluminium filters.
Once the filters are cleaned you can clear the
approximately 3 seconds to do this. The
the appliance will operate normally.
Note: To clear the
If you want to continue to use the appliance while the
touch
and fan speed will be displayed temporarily and then
again. The fan will continue to operate.
Note: The
indication will be displayed after approximately 60 hours of fan opera-
tion.
34
7
9
indication, the appliance must not operate.
10
8
indication. Touch and hold
symbol will be shown on the display and
indication is not cleared,
for
will be displayed