Husky C803H Guía De Uso Y Cuidado página 13

Installation
1
Anchoring of the air compresor
WARNING: Risk of bursting. Excessive vibration
can weaken the air tank and cause an explosion. The
compressor must be properly mounted.
The air compressor must be bolted to a level, solid
concrete surface. Use lag screws (CC), washers (AA),
and concrete anchors (BB). If help is needed anchoring
the air compressor, consult a licensed contractor. The
use of vibration pads (E110586) under the tank feet is
also recommended.
□
Place the air compressor on a level, solid
concrete surface. Make sure the concrete is in
good condition with no cracks or damage.
□
Mark the surface using the holes in the air
compressor feet (J) as a template.
□
Drill holes in the surface for the concrete
anchors. Install the concrete anchors (BB).
□
Line-up the holes in the surface with the holes in
the air compressor feet (J).
□
Place the washers (AA) between the floor and
the air compressor feet, as shown. If needed, use
shims (DD) to level the unit.
□
Place the lag screws (CC) through the air
compressor feet (J), washers (AA), and into the
anchors (BB).
□
Torque the lag screws (CC) to 7-10 ft.-lbs
(9.5-13.5 Nm).
AA
DD
13
Please contact 1-888-43-HUSKY for further assistance.
CC
J
Surface Line
BB
HUSKYTOOLS.com