Toyotomi Zibro RS 30 Instrucciones De Uso página 13

MANUAL
A
INSTALLING THE HEATER
1 Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
¼ a manual fuel pump
¼ a transportation cap
¼ these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
2 Remove the other packaging materials:
¼ Remove the packaging material from the grill
(Fig. B) and pull it forward.
¼ Pull both ends of the packaging to the rear and at the same time slightly
downwards (see Fig. C).
¼ Remove the combustion chamber
packaging (see Fig. D).
¼ Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle ¿ (Fig. E). Close the grill: Slightly lift it to
reposition it in its slot.
¼ Open the lid of the removable tank
3 Fill the removable tank as indicated in Section B.
4 Insert the batteries into their holder µ at the back of the heater (Fig. F).
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing. It is best to use new alkaline batteries (4x C-size).
5 The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not correct the situation by placing books or other goods
under the heater.
6 Your heater is now ready for use.
!
Do not use the heater at a height of over 1500 meters.
A
. Lift the grill from the slot
from the heater and remove the
and remove the piece of cardboard.
4
5