4. After using the dryer, set the airflow regulator (C) to the
USING THE CONCENTRATOR (B)
•
The air concentrator will enable you to point the air flow at a specific point.
•
Use of the concentrator is recommended for drying or styling localised areas of your hair,
especially when using a comb or curlers.
•
To attach the concentrator, fit the tabs on the accessory into the slots of the dryer air
outlet and rotate a few degrees in a clockwise direction.
USING THE DIFFUSER (F)
•
After removing excess water with the dryer, apply styling mousse all over your hair.
•
Fit the diffuser to the dryer.
•
Tilt your head to one side and point the dryer-diffuser upwards. Start drying from the
back, since this area takes longer to dry than the front.
•
As you dry locks of your hair, switch off the dryer and massage the lock in your hand until
it cools down. Repeat this operation until all the locks are dry.
•
Finish off with a gentle circular massage using the fingers of the diffuser, which will give
volume to the roots.
USING THE COLD AIR BUTTON (E)
•
Cold air sets the style achieved using heat and gives shine to the hair.
•
Once you have dried and set the shape of the lock of hair, press the cold air button for 15
or 20 seconds for a perfect result.
Cleaning and Storage
Only clean the appliance when it is cold. Do not use any solvents, detergents or abrasive
products.
1. Unplug the appliance.
2. Use a dry cloth.
3. Clean the grill on the air intake side of the hairdryer regularly in order to avoid excessive
temperatures as a result of heat accumulation. Remove any dirt that is present. If
necessary, a fine brush can be used.
4. Clean the attachments with a moist cloth or by rinsing them under the tap.
5. Remove the attachments from the appliance before cleaning them.
STORAGE
•
Always unplug the appliance before storing it.
•
Put the appliance in a safe place and let it cool down.
•
The mains cable should only be wound up loosely. Never tie the cable tightly round the
device, as over time this may result in the cable breaking.
•
Check the mains cable regularly for damage.
O
position.
3
English