Publicidad
Idiomas disponibles
Idiomas disponibles
MANUAL
A
INSTALLING THE HEATER
1
Carefully remove your heater from the
box
In addition to the heater you also need
to have:
a transportation cap
these directions for use
a manual fuel pump
Keep the box and the packaging
materials (Fig. A) for storage and/or transportation.
2
Remove the other packaging materials:
Release the right side of the grill ¶ from the two slots by pulling the right
side of the grill to the left and then pull it forward (Fig. B).
Pull both ends of the packaging to the rear and at the same time slightly
downwards (see Fig. C).
E
Remove the combustion chamber ¿ from the heater and remove the pack-
aging underneath (see Fig. D).
Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle ´ (Fig. F). Close the grill: Slightly lift it to
reposition it in its slot.
Open the lid of the removable tank º and remove the piece of cardboard.
If the left side of the grill has been removed, first insert the flattened upper left
end of the grill into the upper left slot and then insert the other flattened end
into the lower left slot (Fig. E).
G
3
Fill the removable tank as indicated in Section B.
Insert the batteries into their holder ¹ at the back of the heater (Fig. G).
4
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing. It is best to use new alkaline batteries (4x D-size).
5
The floor should be firm and completely level. Reposition the heater, when it is
not level. Do not correct the situation by placing books or other goods under the
heater.
6
Your heater is now ready for use.
B
FILLING FUEL
Do not fill the removable tank in the living room, but in a more suitable place
(there can always be some spillage). Follow the procedure below:
1
Make sure that the heater is switched off.
and
check
the
contents.
53
Publicidad
