Publicidad
Idiomas disponibles
Idiomas disponibles
Power
Battery
indicator
indicator
Blinking
Lighting Up
Blinking
013900
Nylon cutting head
NOTICE:
Do not attempt to bump feed the head while the
•
trimmer is operating at a high RPM. Bump feeding
at a high RPM may cause damage to the nylon
cutting head.
The bump feed will not operate properly if the
•
head is not rotating.
013811
The nylon cutting head is a dual grass trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating at a
low RPM.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance."
Status
Battery power has been
nearly used up.
Battery protector is
shutting off the power -
battery power has been
used up.
Overheat protector is shutting
off the power - overheating.
1. Most effective
1
cutting area
Replace the battery with fully charged one.
Replace the battery with fully charged one.
Rest and cool down the equipment
for a while.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the trimmer. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Only for model XRU05
1
1
013831
To mount the attachment to a power unit:
1.
Make sure that the lever is not tightened.
2.
To open the entrance of the joint, depress the
joint cover.
9
Action to be taken
1. Joint
2. Lock lever
2
3. Joint cover
3
4. Lever
2
5. Pipe (Cutting
4
tool side)
5
Publicidad
