Publicidad
Step 22
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (M) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (5K) to the DOOR (M). Use a GOLD 1"
å
MACHINE SCREW (50S).
Peel the FELT DISC from the FELT DISC CARD (1M). Stick
å
a FELT DISC on the DOOR where it comes in contact with
the RIGHT END (A).
See the next step for DOOR adjustments.
å
5K
GOLD 1" MACHINE SCREW
(1 used for the KNOB)
www.sauder.com/services
1M
M
1M
50S
B
A
420474
Stop
Mounting
screw
Hinge
Page 27
Publicidad
