Lamellen Filter; Motor Protection Filter - Kompernaß KH 1410 Instrucciones De Uso

Lamellen filter

To take the lamellen filter out, proceed as follows:
Attention!
Before taking the filter out, remove the plug
from the power socket. The appliance could be
inadvertantly switched on.
1. Remove and empty the dust collector
described in the chapter „Emptying the dust
collector".
2. Take off the cover
with the lamellen filter
3. Turn the filter grill
4. Turn the lamellen filter
removed.
Should the lamellen filter
heavily soiled, rinse them both thoroughly under
clean running water.
Attention!
Do not use a brush for cleaning! The lamellen filter
could be damaged!
9
t as
of the dust collector t
and the filter grill
, until it can be removed.
, until it can be
and the filter grill
Afterwards allow the lamellen filter
grill to dry out (ca. 15 hours at room temperature).
Replace the lamellen filter
only when they are both completely dry.
5. To reassemble the dust collector
the opposite sequence.

Motor protection filter

Attention!
Before taking the filter out, remove the plug
the power socket.
1. Open the housing lid
2. Take out the motor protection filter
move the vacuumed in particles from the filter
. and the grill lying behind it.
Notice:
Should the motor protection filter
soiled, rinse it thoroughly under clean running
be water. Afterwards allow it to dry out ( ca. 15 hours
at room temperature). Replace it only when it is
completely dry.
3. Replace the motor protection filter
4. Close the housing lid
- 26 -
and the filter
and the filter grill
t proceed in
9 from
q .
and re-
be heavily
.
q .