Orbegozo CV 2300 Manual De Instrucciones página 11

CV 2300
 Keep the device clean. Never insert objects into the
ventilation slots, as this may cause electric shock, fire
or damage to the heater.
ASSEMBLY OF THE HEATER
Fitting the feet:
Carefully turn the unit upside down.

Use 4 screws for feet to fix the 2 feet onto the heater.

Take care to ensure that they are located correctly in the bottom ends of the heater side

mouldings.
 Use 2 plastic wall plugs and 2 screws (long one) to fix the below left and right brackets onto the
Wall.
OPERATION OF THE HEATER
 NOTE: It is normal when the heaters are turned on for the first time or when they are turned on
after having not been used for a long period of time the heaters may emit some smell and fumes.
This will disappear when the heater has been on a short while.
 Choose a suitable location for the heater, taking into account the safety instructions above.
 Insert the plug of the heater into a suitable socket.
 Turn THERMOSTAT KNOB fully in a clockwise direction to the maximum setting.
 Turn on the heating elements by means of HEATER SWITCHES on the side panel. When the
heating elements are on the switches will illuminate. For maximum heat output both switches
should be on.
 When the desired room temperature has been reached, the thermostat knob should be turned
slowly anti-clockwise until the thermostat is heard to click off and the lights on the element
switches are seen to go out. After this the heater will keep the air temperature in the room at the
set temperature by switching on and off automatically.
11