Cleaning And Maintenance; Cleaning The Appliance - Imetec P1501 Instrucciones De Uso

WARNING! The vacuum cleaner has a motor protection thermostat that is
activated in the event of overheating (caused by a blockage in the inlet
opening, the filters, etc.). If it is activated, switch off the appliance by
pressing the ON/OFF (7) switch and leave it to cool completely for a
couple of hours. Check whether dust is blocking the filters or the inlet
opening before switching the appliance back on.

CLEANING AND MAINTENANCE

WARNING! Always disconnect the appliance from the socket
before cleaning or performing maintenance.
CAUTION!Periodically verify that filters and the inlet opening
are not clogged.
CAUTION!DO NOT use solvents or other aggressive or
abrasive detergents in order not to damage the appliance
surfaces.
CAUTION! Empty the dust container and clean the filters
after every use in order not to damage the appliance.
WARNING! Let the filters dry completely after washing them
for at least 24 hours before reassembly.
WARNING! Make sure all cleaned parts are completely dry
before reusing the appliance.

CLEANING THE APPLIANCE

When necessary, clean the appliance with a damp cloth.
CLEANING THE COMBINED CARPET/HARD FLOOR BRUSH (4)
With the motor on, rub the brush with your hand to remove the remaining dust and fluff, which
must be sucked up directly.
CLEANING THE DUST COLLECTION SYSTEM (16)
• Clean the dust collection system, following the instructions below and paying attention to
the figures in the illustrative guide.
• Turn the base of the flexible suction hose (7) anticlockwise and disconnect it from the
appliance.
EN
16