Publicidad
Idiomas disponibles
Idiomas disponibles
D
B
E
A
C
F
10. Disconnect the extension cord from the
receptacle first and then from the engine.
11. Run the engine 2-3 minutes at idling speed
before you start to throw snow.
To operate the product
CAUTION: Do not operate without snow
or water to lubricate the auger blades.
Incorrect use can cause high
temperatures in the auger blades,
especially if the product is new. This can
cause damage to the auger blades and
scraper bar.
CAUTION: Do not partially engage drive
or auger levers for an extended period of
time; this can lead to premature wear or
burning of the belts.
Note: When both the drive engagement and auger
engagement are engaged, the drive engagement will
lock the auger engagement in position. Use the right
hand to control the snow discharge chute.
Note: Do not change the speed when the drive lever
is engaged. This can cause damage to the
transmission.
1. To engage the auger blades, push the auger
engagement (A) to the handle to engage the
auger and throw snow.
12
H
2. Raise the drive speed control lever (B) from the
G
3. Lower the drive speed control lever from the
4. To make the product move in the selected
5. If the product has power steering, hold the left
middle position to make the product move
forward when the drive engagement (C) is
engaged. Do not change the speed when the
drive lever is engaged. This can cause damage
to the transmission.
middle position to make the product move
rearward when the drive engagement is
engaged.
C
direction, hold the drive engagement (C) against
the handle .
steering trigger (D) to turn left. Hold the right
steering trigger to turn right.
A
B
D
791 - 002 - 08.01.2020
Publicidad
