How To Use; Caution On Lithium-Ion Battery - Metabo HPT DH 18DBL Manual De Instrucciones

English
Remaining battery
indicator switch
NOTE
○ Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
○ To save the battery power consumption, the
remaining battery indicator lamp lights while pressing
the remaining battery indicator switch.
8. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the tool.
(Fig. 13)
The LED light will automatically turn off 10 seconds
after the switch is released.
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
14
Remaining battery
indicator lamp
Fig. 12
Switch trigger
Fig. 13
9. Selecting the function mode
You can switch functions to the 3 modes of "hammering
only", "rotation + hammering", and "rotation only"
by turning the change lever while pressing the push
button. Set the mark position of the change lever
to that of the mode to be used.
CAUTION
● Before operating the change lever, check and
make sure that the motor has stopped.
A failure can occur if it is operated while the
motor is running.
● To operate the change lever, press the push
button, and release the lock of the change lever.
Also, check and make sure after operation
that the push button has returned and that the
change lever has been locked.
● Switch the change lever without mistake.
If it is used at a position halfway, there is a fear
that the service life of the switching mechanism
may be shortened.

HOW TO USE

CAUTION
● To prevent accidents, make sure to turn the
switch off and disconnect the battery when the
drill bits and other various parts are installed
or removed. The power switch should also be
turned off during a work break and after work.

CAUTION on lithium-ion battery

● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
1. Switch operation
○ When the switch trigger is depressed, the tool rotates.
When the switch trigger is released, the tool stops.
○ The rotational speed of the rotary hammer can be
controlled by varying the amount that the switch
trigger is pulled. Speed is low when the switch trigger
is pulled slightly and increases as the switch trigger is
pulled more.
○ When releasing the switch trigger, the brake will be
applied for immediate stopping.