Orbegozo SV 1260 Manual De Instrucciones página 8

SV 1260
getting hot.
CHARACTERISTICS AND STRUCTURE
OPERATING
 Set the temperature control to the suitable position.
 Wait until the pilot light goes off and it comes on again. Then you can start ironing.
 The pilot light will turn on and off during the ironing process. It does not affect to the process.
 While the iron is hot and not in use, place it upright on a stable surface.
 Once finished:
o Set the temperature control to the minimum level and unplug the device
o Let the iron gets cold during 30 minutes. Put the iron on its rear side.
o Store it in this position to prevent damage in the soleplate.
MAIN TECHNICAL PARAMETERS
Disposal of old electrical appliances.
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), requires that
old household electrical appliances must not be disposed of in the normal unsorted municipal waste
stream. Old appliances must be collected separately in order to optimize the recovery and recycling of
the materials they contain, and reduce the impact on human health and the environment. The crossed
out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of the
appliance, it must be separately collected. Consumers should contact their local authority or retailer for
information concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage Directive
2014/35/EU and the requirements of the EMC directive 2014/30/EU.
Model Voltage
SV 1260 220-240V
1. Handle
2. Cord Protect
3. Temperature controller
4. Soleplate
5. Indicator light
Frequency Power
50/60Hz 1200 W
8