Publicidad
Idiomas disponibles
Idiomas disponibles
1. Insert the battery (4) into the base of the machi-
ne as shown in Fig. F.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. A, F)
1. Push the battery unlock button (5)
2. Pull the battery out of the machine like shown
in Fig. F.
Checking the battery charging status (Fig. G)
• To check the battery charge status, push the
button (13) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. G)
1. Take the battery (4) from the machine.
2. Turn the battery (4) to upside down position and
slide it onto the charger (15) as shown in Fig. G.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on the
charger (16) will lighten up and show the charger
status.
The charger has 2 LED indicators (16) which indica-
te the status of the charging process:
Red LED Status
Green LED status
Off
Off
Off
On
On
Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
WWW.VONROC.COM
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
Replacing the saw blade (Fig. A, C)
Mounting the saw blade
1. Turn the clamping lever (9) as far to the left as
possible and hold it in this position.
2. Insert the saw blade in the chuck (8). Check
that the saw blade is securely fixed and that the
teeth are pointing downwards.
3. Let go of the clamping lever. Check whether the
saw blade is locked in place.
Make sure to use the right sawblade for the corres-
ponding material. Included with the machine is a
coarse sawblade for wood and a fine sawblade for
metal and plastics.
Charger status
Removing the saw blade
No power
1. Turn the clamping lever (9) as far to the left as
possible and hold it in this position.
Standby mode:
2. Remove the saw blade from the chuck (8).
- No battery is
3. Let go of the clamping lever.
inserted or,
- Battery inserted
4. OPERATION
but charging has
finished
Switching the machine on/off (Fig. A)
Battery charging in
The on/off switch (2) is used for activating the
progress
machine and adjusting speed.
• To start the machine, press and hold the lock-
off button (1) and press the on/off switch (2).
• The further the on/off switch (2) is being
pushed, the faster the blade will move. The
required speed depends on the material and
can be determined by practical testing.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
When mounting the saw blade, wear
protective gloves. Danger of injury when
touching the saw blade.
Only use saw blades that correspond with
the characteristic data given in the
operating instructions.
Make sure the blade holder is free of material
debris (such as splinters of wood or metal).
EN
9
Publicidad
