Bosch Professional GTS 10 J Manual Original página 35

Symbols and their meaning
Left-hand side:
Indicates the direction of rotation of the crank for lowering
(transport position) and raising (work position) the saw
blade.
Right-hand side:
Indicates the position of the locking lever for securing the
saw blade and setting the bevel angle (saw blade can be
swivelled).
Oil the power tool as necessary at the
points indicated.
Protection class II power tools are
strengthened or double-insulated.
The CE mark provides confirmation from
the manufacturer that the power tool
complies with the applicable EU Direct-
ives.
Product description and
specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is a stationary machine for cutting in a
straight line with and against the grain in hardwood, soft-
wood, chipboard and fibreboard. Mitre angles of -60° to
+60° as well as bevel angles of -2° to 47° are possible.
When using appropriate saw blades, sawing aluminium pro-
files and plastic is also possible.
Product features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Guide groove for parallel guide
(2) Scale for spacing between saw blade and parallel
guide
(3) Angle guide
(4) Recessed handles
(5) Guide groove for angle guide
(6) Protective cover
(7) Riving knife
(8) Saw table
(9) Parallel guide
Bosch Power Tools
(10) V guide groove on the saw table for the parallel
guide
(11) Mounting holes
(12) Carrying handle
(13) Saw table expansion
(14) Fixing clip for the GTA 600 saw stand
(15) Clamping handle for saw table expansion
(16) Locking lever for setting the bevel angle
(17) Hand wheel
(18) Crank for raising and lowering the saw blade
(19) On/off switch safety flap
(20) Hex key (2 mm)
(21) Hex key (5 mm)
(22) Ring spanner (23 mm)
(23) Push stick
(24) Adjusting screw for adjusting the clamping force of
the parallel guide
(25) Table insert
(26) Saw blade
(27) Magnifying glass
(28) Profile rail
(29) Cable holder
(30) Holding clip for storing the additional parallel
guide
(31) Chip ejector
(32) Dust extraction adapter
(33) Bracket for storing the protective cover
(34) Clamping lever for riving knife
(35) Positioning pins for riving knife
(36) Recesses for table insert
(37) Clamping lever for protective cover
(38) Guide pin for protective cover
(39) Clamping handle of the parallel guide
(40) V guide of the parallel guide
(41) Additional parallel guide
(42) "Additional parallel guide" fastening set
Guide rail of the angle guide
(43)
(44) "Profile rail" fastening set
(45) Fastening screw for chip ejector
(46) Clamping nut
(47) Spindle locking lever
(48) Clamping flange
(49) Tool spindle
(50) Mounting flange
(51) Bevel angle indicator
(52) Scale for bevel angles
(53) Locking knob for all mitre angles
English | 35
1 609 92A 5C2 | (26.07.2019)