Publicidad
Idiomas disponibles
Idiomas disponibles
5. Touch the "Alarm/hold 3 sec for Filter Reset"
button (
(Filter Reset)
water filter. The color of indicator (
from red to indicator OFF.
6. If you turned off the water
supply, turn it back on.
For a replacement water filter,
you can visit your local home
Improvement center or contact
the Samsung Parts distributor.
Be sure the replacement water filter has the
SAMSUNG logo on the box and on the water filter.
Link : http://www.samsungparts.com
Removing any residual matter inside the
water supply line after installing the water
filter.
1. Turn ON the main water supply and supply water
from water supply line.
2. Run water through the dispenser until the water
runs clear (approx. 6 to 7 minutes). This will clean
the water supply system and remove air from the
lines.
3. Additional flushing may be
required in some households.
4. Open the Refrigerator door
and make sure there are no
water leaks coming from the
water filter.
Be sure to flush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace
the filter if necessary.
• Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
• If your refrigerator has a water filter, it may
further reduce the water pressure when used
14_ operating
DA68-02481A-10.indb 14
) for about 3 seconds to reset the
) changes
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualified plumber.
CONTROLLING THE TEMPERATURE
Basic temperature of Freezer and
Refrigerator Compartments
The basic temperature and recommended
temperatures of the Freezer and Refrigerator
Compartments are -2°F and 38°F (or -19°C and
3°C) respectively. If the temperature of Freezer and
Refrigerator Compartments are too high or
low, adjust the temperature manually.
Controlling the Freezer temperature
Recommend Temp (Freezer) : -2°F (or -19°C )
The Freezer temperature can be set between -8°F
and 8°F (or between -22°C and -14°C) to suit your
particular needs. Press the Freezer button repeatedly
until the desired temperature is shown in the
temperature display. The temperature will change by
2°F (or 1°C) with each press. See below.
Fahrenheit : -2°F → -4°F → -6°F → -8°F → 8°F → 6°F
→ 4°F → 2°F → 0°F → -2°F.
Centigrade : -19°C → -20°C → -21°C → -22°C →
-14°C → -15°C → -16°C → -17°C → -18°C → -19°C.
Keep in mind that foods like some ice cream may melt
at 4°F (or -15.5°C ). The temperature display will move
sequentially from -8°F to 8°F (or from -22°C to -14°C ).
Controlling the fridge temperature
The fridge temperature can be set between 34°F and
46°F (or between 7°C and 1°C) to suit your particular
needs. Press the Fridge button repeatedly until the
desired temperature is shown in the temperature
display. The temperature will change by 2°F (or 1°C)
with each press. See below.
Fahrenheit : 38°F → 36°F → 34°F → 46°F → 44°F →
42°F → 40°F → 38°F.
Centigrade : 3°C → 2°C → 1°C → 7°C → 6°C → 5°C
→ 4°C → 3°C. The temperature control process for the
Fridge works just like the Freezer process. Press the
Fridge button to set your desired temperature.
13. 4. 25.
2:18
Publicidad
