S&P METEOR EC Manual Del Usuario página 9

• Children should not play with the product.
• Before carrying out any maintenance work, or during long periods without use, make sure
that the device has been disconnected from the mains.
• Do not clean the product while it is working and do not immerse it in water.
• Do not handle the heater with wet hands.
• Do not coil the power cable around or in top of the product while it is working.
• If the fl exible power cable is damaged, it should only be replaced in S&P Repair Workshops
or by qualifi ed staff in order to avoid a dangerous situation.
• This appliance always must be working in a vertical position with base over a stable fl oor.
• Only for internal use
• Do not use this heater in the immediate vicinity of a bathtub, shower or swimming pool.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of damage to the heater.
• Use this heating appliance on a horizontal and stable surface, or if possible fi x it to a wall.
• WARNING: Do not use this heater in rooms that are occupied by persons who cannot leave
the room by themselves, unless permanent surveillance is provided.
• WARNING: To reduce the risk of fi re, keep textiles, curtains, or other fl ammable material at
least 1m away from the air outlet.
2. DESCRIPTION OF THE PRODUCT (fi g. 1)
a Front exhaust air grille (rotation 360º)
b Front grille knob
c Light
d Control knob (heater /fan)
e Thermostat
f Transport handle
g Power wire keeper
3. USE AND OPERATION
Fan mode
• Make sure the power supply corresponds to the details shown on the rating label.
• Turn the control knob (Fig.1d) in the direction of clockwise, you can select up to 3 different air speeds. Low / Middle /
High air speed (positions indicated in black colour).
Heater mode
• Make sure the power supply corresponds to the details shown on the rating label.
• Turn the control knob (Fig.1d) in the direction of anticlockwise, you can select up hot air (position indicated in red
colour).
• Turn the thermostat command (Fig.1e) in the direction of clockwise to its maximum position. Once the room has reached
the desired temperature, turn the thermostat command anticlockwise until you hear a slight "click". When the thermos-
tat control is in this position, the heater will connect and disconnect automatically to keep the pre-selected temperature
constant.
EN
9