WAGNER F500 ELECTRONIC LED Manual Del Usuario página 5

FURNO 500
Protective Cap
WARNING - Remove plastic cap
and discard before using your heat
gun.
Using the Heat Gun
General Description
This Heat Gun is a quality power tool. Like any power tool, it can be
dangerous when misused. Read the following instructions carefully and
follow all safety precautions. It is the responsibility of the owner to use
the Heat Gun properly.
Specifications
Housing Engineered high-impact corrosion and heat-
resistant polymers
Wattage 2000 Watts on HIGH, 150 Watts on LOW
Voltage 220 - 240 V a.c.
Frequency 50 - 60Hz
Heat Output Approximately 600°C on HIGH, approximately
60°C on LOW
Weight 0.9 kg
Features Fig. 1
1) Control panel - temperature and fan speed
2) Hanging hook
3) Cordset with integrated stabilizers (removable with tool)
4) Rear stabilizer fins (upright standing)
5) Side bars to prevent nozzle touching surface
6) Nozzle Heat Shield
Fig. 1
6
Removing the barrel cover
The barrel cover can be removed when working in hard to reach
locations. BE CAREFUL OF THE NOZZLE. Increased risk of burning
exists when working without the barrel cover. To remove the barrel
cover, use a small flat head scew driver to lift tab (Fig. 1, 7) over raised
area.
7
5
2
EN
1
4
3
5