Hitachi CC 14SF Manual De Instrucciones página 7

WARNING
For Your Own Safety Read This Instruction Manual Before Operating The Cut-Off Machine.
1. Always wear eye protection, when using the tool.
2. Always keep hands out of the line of the cut-off wheel.
3. Never operate the tool without the guards in place.
4. Never perform any freehand operation with the tool.
5. Never reach around the cut-off wheel.
6. Always shut off the power and wait for the cut-off wheel to stop turning before adjusting
or maintaining the tool.
FOREWORD
The information contained in this manual is designed to assist you in the safe operation
and maintenance of the POWER TOOL. Some illustrations in this manual may show details
or attachments that differ from those on your own POWER TOOL.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
Repairs should be conducted only by a Hitachi authorized service center.
POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider
than the other.) This plug will fit in a polarized outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install a polarized outlet. Do not change the plug in any
way.
DOUBLE INSULATION FOR SAFER OPERATION
To ensure safer operation of this electric power tool, HITACHI has adopted a double insulation
system. "Double insulation" as used here, means a system of two insulations physically
separated and arranged between electrically conductive materials connected to the power
supply and to the outer frame handled by the operator. Therefore, the nameplate shows
both the " " mark and "Double insulation" or either one on the power tool.
Although this system has no external grounding, you must still follow the normal safety
precautions given in this manual.
To keep the double insulation system effective, follow these precautions;
* To avoid lessening the double insulation-feature, always get in touch with your dealer
or an authorized HITACHI power tool repair shop when assembling, disassembling or
replacing parts other than accessories or carbon brushes.
* Clean the exterior of the tool with a soft cloth moistened in soap water, and dry
thoroughly.
Don't use chloric solvent, gasoline or thinner on plastic components; otherwise they
might dissolve.
English
7