Publicidad
Idiomas disponibles
Idiomas disponibles
3. Use a 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifice from the end of gas valve. The main burner
orifice is located behind the LP orifice, so no additional orifice
needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the orifice is properly installed
inside of the burner opening.
4. Reinsert the burner and reattach using the 2 screws
previously removed. Repeat the procedure for each main
burner.
5. Position the igniters so they are ¼" (6.0 mm) away from each
burner.
Change the Rotisserie/Infrared Burner Orifice
1. Using a Phillips screwdriver, unscrew the 2 screws and
remove the rotisserie/infrared burner wind baffle.
A. Wind baffle
A
A
2. Using a Phillips screwdriver, remove the 4 screws at the back
of grill from inside the grill (2 screws on each side of the
rotisserie infrared burner).
3. Remove the access cover at the back of the grill hood by
removing the 4 screws (2 screws on each side of the
rotisserie infrared burner).
A
A. Access cover
4. Using a Phillips screwdriver, remove the 2 screws holding the
spider guard to the burner.
A. 2 screws
13
Publicidad
