Publicidad
Idiomas disponibles
Idiomas disponibles
How to Wire Your Ceiling Fan - Pull Chain
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
▲WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Connect the green/yellow grounding lead from the
hanger ball and the green/yellow grounding lead from the
hanger bracket to the supply grounding conductor (this
may be a bare wire or wire with green colored insulation).
Securely connect wires with wire connectors supplied.
2. Securely connect the blue fan motor wire to the blue
supply (neutral) wire using wire connector supplied.
Securely connect the brown fan motor wire and orange
wire to the live supply (normally black but marked as a
live supply with red sleeving) (Figure 8). Make sure all
connections are secure.
INSTALLATION NOTE
If separate control of light fi xture (optional) is desired,
a separate switch leg from the outlet box is required. In
this instance the blue wire from the fan will be connected
to the light switch leg (typically orange wire)
1. Restore electrical power to the outlet box by turning the
electricity on at the main fuse box.
2. Check the operation of the fan by gently pulling on the
pull chain switch. (Figure 9)
3. If airflow is desired in the opposite direction, turn the
fan off and wait for the blades to stop turning. Then slide
the reverse switch to the opposite position and turn fan
on again. Your fan model is equipped with a 4-position,
3-speed, pull chain switch. The operating sequence is as
follows:
1st Pull = HIGH
2nd Pull = MEDIUM
Operating Instructions - Pull Chain
3rd Pull = LOW
4th Pull = OFF
Blue Wire
(Neutral)
Grn/Yel Wire
(Earth/Gnd)
Grn/Yel Wire
(Earth/Gnd) from
Hanger Bracket
Grn/Yel Wire
(Earth/Gnd) from
Fan Motor
Blue Wire
(Neutral)
3. Secure the ceiling canopy to the hanger bracket with
threaded rods, external lockwashers, and knurled knobs
provided (see page 10). Your fan is now wired to be
turned on and off from the fan pull chain speed control.
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
Speed Control
Pull Chain
7
Brown Wire
(Live)
Listed
Outlet Box
Household
Supply
N L1 L
Brown Wire
(Live)
Orange Wire
(Light Kit)
Figure 8
Reversing
Switch
Figure 9
Publicidad
