Wi-Fi (Wi-Fi Model Only)
5
Enables connection of the air conditioner to
the home Wi-Fi.
NOTE
• Follow instructions on ThinQ application
on how to connect to your unit.
Clean Filter
6
The Clean Filter LED lights up to notify you
that the filter needs to be cleaned. After
cleaning the filter, press Temp
together on the control panel to turn off the
Clean Filter light.
NOTE
• The filter reset must be done using the
control panel, not the remote control.
• This feature is a reminder to clean the
air filter for more efficient operation.
The LED light turns on after 250 hours
of operation.
Temperature Control
7
The thermostat monitors room
temperature to maintain the desired
temperature. The thermostat can be set
between 60 °F–86 °F (16 °C–30 °C).
Press
or
decrease temperature setting.
NOTE
• Auto Restart : If the air conditioner turns
off due to a power outage, it will restart
automatically once the power is restored, with
the same settings as were set before the unit
turned off.
• Energy Saver : The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
• The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
and
arrows to increase or
Wireless Remote Control
Inserting Batteries
1
Push out the cover on the back of the remote
control with your thumb.
2
With the plus and minus poles facing as
marked, and insert two new AAA 1.5 V
batteries.
3
Reattach the cover.
NOTE
• Two new batteries are supplied with the air
conditioner for use in the remote control.
• Do not use a rechargeable battery. Make sure
that the battery is new.
• In order to prevent discharge, remove the
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
• Keep the remote control away from extremely
hot or humid places.
• To maintain optimal operation of the remote
control, the remote sensor should not be
exposed to direct sunlight.
EN
17