Publicidad
Idiomas disponibles
Idiomas disponibles
ANTENNA CONNECTION
Connect the CB antenna to the ANT socket on the back of your radio. The antenna must be tuned
to the CB radio band. For this use a SWR meter. For a good radio range, the SWR should not
exceed a value of 2. A high SWR also points to defects in antenna, cable, or a short circuit in the
antenna line. Never transmit without a connected antenna!
Note: The radio antenna must be installed away from other antennas and interference sources
as much as possible. CB antennas must be mounted usually on the vehicule's highest part, on a
metal surface. A sufficiently large metal surface is essential for the function of the antenna. For
installation on a fiberglass cabs or plastic wind deflectors, special antennas must be used.
OPERATION
•
Power On/Off the radio: Turn the radio on by turning the knob [6] clockwise. The current
standard, then the selected channel, will appear on the screen for one second. Turn knob [6]
anti-clockwise to stop the radio.
•
Volume control: Continue to turn the knob [6] clockwise to adjust the volume to the desired
level.
•
Channel selection: Press the keys [5] on the radio or the up/down keys on the microphone
to change the channel number.
•
Squelch level control: Press the [2] key briefly. The current squelch level will appear on the
screen. Use the up/down keys to select the desired SQ level (from 0.1 to 2.8) or OF to disable
the function.
0.F = Squelch off
0.1 = Lowest Squelch level
2.8 = Highest Squelch level
Note: High SQ level require a stronger signal..
ASQ control: Long press the [2] key to activate the ASQ function. The "AQ" icon and the
•
current ASQ level will appear on the screen. Use the up/down keys to select the desired ASQ
level (from A.1 to A.9). Press the [2] key long to deactivate the ASQ function.
A.1 = lowest level
A.9 = highest level
Note: High DS level require a stronger signal.
Modulation type: Briefly press the [7] key to change between AM and FM. The selected
•
modulation will appear on the screen.
Note: Before modifying the modulation, check the selected standard.
•
RF Gain control: Press the [3] key briefly. The "R" icon will appear on the screen and the
current RF gain level will blink. Use the up/down keys to change the level (06, 12, 18, 24, 30,
36, 42, 48, 54).
•
Emergency channel: Press the [4] key briefly. The channel number 09 blinks on the screen.
Press again, the channel number will blink 19 on the screen. Press the third time to return to
the normal channel.
Key Lock: Press long the [4] key. The "LC" icon will appear on the screen. Key lock function
•
is active. Press the [4] key again, OF will appear on the screen. The key lock function is
disabled.
•
Scan function: Press long the [7] key to start channel scanning. The "SC" icon appears on
the screen. Use the up/down keys to change the direction of the scan. Press the [7] key or the
PTT key on the microphone again to deactivate the scan function.
6
Publicidad
