Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
APPLICATIONS
Shrub shear (CH10DL)
Fine trimming hedges
Trimming and pruning garden trees
Grass shear (CG10DL)
Trimming lawns
REMOVAL AND INSTALLATION METHOD
OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 3).
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch (2 pcs) of the battery (Fig. 3).
Handle
Insert
Pull out
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
ASSEMBLY AND OPERATION
Latch
Battery
Push
Fig. 3
1. Insert the plug of battery charger into the
receptacle.
WARNING:
Do not use the electrical cord if
damaged.
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4.
Battery
3. Charging
When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light on.
NOTE:
If the pilot lamp does not light, pull out the plug
from the receptacle and check if the battery is
properly mounted.
When the battery is fully charged, the pilot lamp
will go out.
NOTE:
The battery charging time becomes longer when
a temperature is low or the voltage of the power
source is too low.
When the pilot lamp does not go off even if more
than four hour has passed after start of the
charging, stop the charging and contact your
HITACHI AUTHORIZED SERVICE CENTER.
English
Have
it
repaired
Pilot lamp
Fig. 4
11
Publicidad
Tabla de contenido
Solución de problemas
