EuroLite LED FLO-4 Manual Del Usuario página 21

Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
With the POWER-switch, you can switch the LED Flo-4 DMX on and off. This unit has two operating modes.
It can be run as a Stand Alone-unit or DMX-controlled.
Setting the operation mode
Press the MODE button to select an operating mode:, MANUAL, ROLL, AUTO, DMX.
Stand Alone-Mode
In Stand Alone Mode you can use the LED Flo-4 DMX without a controller.
Manual - Manual RGB Setting
Under this point of the menu, you can set the RGB-values manually. In Manual Mode, the Manual LED
indicator lights up.
Press the MODE-button to select Manual Mode. The display shows (CH1-12) or (AL-R)(AL-G)(AL-B). Press
the FUNC-button to choose the desired mode. Use the UP and DOWN buttons to set values between 000
and 255.
Roll - Selecting Internal Programs
Under this point of the menu, you can select between four internal programs and can set the speed. In Roll
Mode, the Roll LED indicator lights up.
Press the MODE-button to select Roll Mode. The display shows the program ROL-1 or ROL-2 or ROL-3 or
ROL-4 an. Use the UP and DOWN buttons to choose between ROL-1 to ROL-4.
Press the FUNC -button. The display shows SP:xx. Use the UP and DOWN buttons to set speed values.
Auto - Selecting Internal Programs
Under this point of the menu, you can select between six internal programs and can set the program speed
as well as the fade time. In Auto Mode, the Auto LED indicator lights up.
Press the MODE-button to select Auto Mode. The display shows the program P-xx. Use the UP and DOWN
buttons to to choose between P-1 to P-6.
Press the FUNC-button. The display shows SP:xx. Use the UP and DOWN buttons to set speed values.
International
L
N
21/47 00025815.DOC, Version 1.0