MAHLE Digital ADAS Manual De Instalación página 21

7.6
Fitting the metric bar
For easier installation of the metric
bar, raise the structure to the max-
imum, using the special remote
control.
To lift the structure, the power plug
must be connected to the mains.
No. 2 operators are required to mount the metric
bar.
Tools needed:
Phillips screwdriver
n
10 mm socket wrench
n
Tightening torque: 10 Nm
Bar Pre-Assembly
1 Insert the centering bar in one half
of the metric bar and fix it with the
appropriate screws
Place the second half of the metric
2
bar on the centering bar and secure it
with the appropriate screws
Bar assembly on the structure
3 Place the 3 fasteners with screws on
the structure
4 Proceed with the centering of the bar,
positioning it so that its center is in the
middle of the two central posts (22
cm on both sides)
Note: use a measuring tape or laser
rangefinder for accurate measurement
5 Place the screws in the appropriate
holes on the pre-assembled structure
6 Tighten the screws with the self-lock-
ing nuts and flat washers, using the
10 mm socket wrench
Insert the sliding trolleys into the bar,
7
following the order shown in the figure
8 Close the end by refitting the plate
and tightening the fixing screws
21