Publicidad
Idiomas disponibles
Idiomas disponibles
Name
Button light
Light in used capsule container
Fill/refill water
There are two ways to fill the water tank: directly into the machine, by using for example a jug, or by removing the water tank:
• Filling without removing the tank:
• Raise the water tank lid.
• Fill the tank up to the "Max" mark with cold fresh water (the maximum capacity is 0.8 litre), or at least the "Min" mark.
• Low down the lid.
• Filling by removing the water tank:
• Hold the water grip at tilting angle as shown in direction 1 to remove the water tank from the machine.
• Fill the tank up to the "Max" mark with cold fresh water (the maximum capacity is 0.8 litre) or at least the "Min" mark.
• Slide the water tank slowly on water tank base. when the water tank outlet is inserted in the inlet receptacle. pushing firmly on the water
grip as shown in direction 2 to lock the water tank.
Flushing out the machine and internal piping/first use
• Fill water tank to maximum level.
• Plug in appliance to and turn it on.
• The lights on the control buttons are blinking. blue lights in used-capsule container is lighted in blue which goes off after
1 minute.
• Tips: you can check easier if the used container is full or not when the blue light is on.
• The indicator will blink in red for first use, meaning the internal circuit is empty- Please fill up the water and open the handle,
press any button to start pump. once water is detected entering the internal circuit. the red indicators becomes blue.
• The machine starts to heat up automatically when detected water in circuit with 3 buttons blinking.
• The lights on buttons become steady when the machine is heated up, heating up time is 40 seconds approximately.
• Press the lungo coffee button, before pressing the button. make sure that:
• The handle is closed without capsule inside.
• The water tank is full.
• The water tank is in place before brewing. Because there is hot cleaning water coming out during heating up beware
of hot water: danger of scalding!
Status
Each button blinks circularly
Light steady when handle is open
- 5 -
Function
Blinking when
warming up
Light steady
Check if the used capsule
English
Action
Wait for ready
Ready
In energy saving mode
container is full or not
Publicidad
