Holmatro GCT 51 ST EVO 3 Serie Manual página 44

EN
5.9 Attaching accessories
5.9.1 Chain connecting pieces sets and pull chain sets
Chain connecting pieces make it possible to use a combi tool for pulling. The chain connecting pieces
must be placed on the blades. The chain connecting pieces may only be used in combination with the
corresponding pull chain set. These pull chain consist of two parts, each with a shortening hook that
only grabs the chain. The chains are 1.5 m and 3 m long respectively.
WARNING
Hoisting is not permitted with these accessories.
The pulling accessories are intended solely for the horizontal movement of loads.
CAUTION
Check what the load is doing and make sure that it is always supported.
Make sure that the tool can move freely during pulling and always remains in a straight line
between both pulling attachments.
5.9.2 CT 5117
Refer to Fig. 7
• Make sure that the blades are slightly open.
• Slide the latch (A) towards the end of the pulling tip.
• Place the pulling adapter (B) over the spreading tip (C).
• Release the latch (A) so that the pulling tip is locked on the spreading tip.
5.9.3 CT 5160
Refer to Fig. 8
• Make sure that the blades are slightly open.
• Push (A) and pull (B) the pin out untill it locks.
• Remove the spreading tips from the blades (C).
Refer to Fig. 6
• Place the pulling adapters over the blades.
• Push pins in completely untill they lock into the position as shown.
6 Use
6.1 General
The equipment of a rescue system must always be ready for use. That means the equipment must be
checked and inspected directly after use, before it is put away.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use of
all equipment of the system you are going to work with.
6.2 Before use
• Before use, always check the State Of Charge of the battery pack. See section 3.6.
44
All manuals and user guides at all-guides.com
916.001.650_002 GCT 51** (ST) (STA) EVO 3