Publicidad
Idiomas disponibles
Idiomas disponibles
• Remove all packing materials.
• Remove remaining packaging and transit supports (if existing).
• Check the completeness of the packing content.
• Check the appliance, the power cord, the power plug and all accessories for trans-
portation damages.
• Keep the packaging materials as far as possible till the end of the warranty period.
Dispose it into your local waste disposal system afterwards.
WARNING: Packing materials are no toys! Children must not play with plastic
bags! Danger of suffocation!
ASSEMBLY
Prior to mounting an accessory always unplug the tool.
Inserting the bit or drill
• Open the chuck (1).
• Insert the drill or bit in the chuck.
• Tighten the chuck firmly.
Check if the bit or drill is in the centre of the chuck.
Auxiliary handle
The auxiliary handle (8) will provide additional control, support and guidance for the drill.
• Slide the holder of the side grip over the drill chuck on the machine.
• Turn the side grip in the required position and tighten it firmly.
Depth gauge
The depth stop is used to limited the maximum drilling depth.
• Loosen the side grip (8).
• Insert the depth stop (2) in the hole in the holder of the side grip.
• Adjust the depth stop to the required drilling depth.
• Tighten the side grip firmly.
OPERATION
Selecting the operation mode
Select the required operating mode before use (drilling or hammer drilling).
• For drilling in wood, metal, plastics and soft stone, push the switch (3) to the drill
position.
Publicidad
