Publicidad
Idiomas disponibles
Idiomas disponibles
1. Place the product on an even surface so that it is possible to unfold the inner
frame.
2. Remove the locking pin and take out the screw (b).
3. Raise the brackets (d).
4. Lift the inner frame (c) and position it in a way that the holes in it align with
the holes in the brackets.
5. Screw both elements together (d and e) (put the gasket on the screw, insert
the screw through the hole in the bracket and the inner frame, put on the
gasket and tighten with the wing nut).
6. The product is ready for use.
3.3.
Working with the device
Note: Product drawings can be found at the end of the manual on page xxx.
A. Raise the movable frame upwards (g).
B. Place the log on the lower teeth of the stand.
C. Place the log so that 1/3 of its length passes through the frame (c) (as shown
in the drawing) and lower the movable frame (g). Carefully release the log so
that the wood falls on the teeth under its weight and locks itself between the
upper and lower teeth.
CAUTION! The log should be cut from the long side. Heavy logs weighing more
than 25 kg should always be carried by at least 2 people.
ADJUSTING THE HEIGHT OF THE MOVING FRAME
D. The product allows you to change the height of the movable frame to adapt to
the different thicknesses of the held wood. To do this, remove the safety pins
and take out the screws (f). Then move the frame (g) up or down to the
desired height and align the holes of the moving frame with the holes in the
inner frame. Secure again with the screw and the pin.
3.4.
Cleaning and maintenance
a)
Use only non-corrosive cleaning agents for cleaning the surfaces.
b)
Store the appliance in a dry and cool place protected from moisture and direct
sunlight.
c)
Regularly inspect the appliance for technical defects and damage.
d)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
Publicidad
