Vertical Ironing; Filling With Water; Anticalc - System - SOLAC CVG 9600 / C Instrucciones De Uso

VERTICAL IRONING

• Keep the steam button pressed to obtain steam during vertical ironing.
• It enables you to remove creases from delicate garments without having to
lay them on the ironing board: jackets, coats, curtains, suede garments, etc.
• Place the garment on a hanger, away from other garments, persons, ...
• Set the temperature selector at position (••), (•••) or (MAX), place the iron in
the vertical position and press the button. At position (••) you will obtain a
more humid white steam which will be more apparent, whereas at setting
(•••) and (MAX) the steam is drier and, although the same flow is maintained,
it will be harder for you to see.
SPRAY
• With water in the tank, you may spray water over the garment by pressing
the button Fig. 1 (3).

FILLING WITH WATER

• If the water level drops below Min while you are ironing, a whistle will sound
indicating that the water level has to be topped up.
• Unplug the CVG and fill the tank with the beaker that is supplied Fig 1 (12),
in the vertical position as shown in figure Fig 3.
• If the appliance were to run out of water completely, you would hear a
strange noise from the micro-pump. In this case, unplug the appliance
and fill the tank with water. When you switch it on again, this noise
will disappear.

ANTICALC - SYSTEM

If you do not change the resin of your CIS it will be affected by scale just
like other ironing systems.
• The Compact Vapor Generator is fitted with a replaceable anticalc - system consisting
of a resin filter, which retains the limy substances in the water, preventing these from
reaching the steam chamber in the sole-plate and thereby extending the life of your
CVG. If you so wish, on this model you may replace the resin so that the CVG is kept
in optimum condition. If you want to replace the resin, we recommend you to do it
every 6 months. Changing the resin does not mean that you may overlook the advice
about water hardness given in the section "BEFORE STARTING TO IRON" .
• In the event of not changing the resin of this CVG, it will be subject to
the effects of scale just like other irons.
• For replacement and before removing it, make sure there is no water
in the tank.
• Turn the part, situated in the heel of the appliance, in an anticlockwise
direction as far as it will go, and the arrow lines up with the open padlock
(approx. 180º) and pull it back.
16
CVG9600 16 9/4/08, 09:45:08