Tecfrigo OASI 4-8 M FISH Instalación Y Uso página 7

6. CONNECTION TO THE MAINS
1 . Ensure that mains voltage and frequency are the same as those stated on the rating plate
2
to the appliance. . Ensure that the supply socket:
rated current as set out on the rating plate;
magnetic switch (also known as ground fault interrupter) with In = rated value as stated on the rating
plate; - differential with Id sensitivity = 30 mA. 3. Ensure that there is no danger of explosion (AD) in the
4
room. . Make sure the environment is suitable for the power supply cable provided. The cable of the
appliance is H05 VVF, designed for internal use. . Insert the plug in the socket (do not use three-way
adapters and reduction adapters).
rest in its correct position for at least 3 hours before hooking it up to the mains (see fig. 4).
7. CONTROLS (T820H pag. 57)
The appliance features controls situated in a protected panel on one of the machine's sides. 1. Cover
lifting switch: to open and close the cover - Position II to lift - Position O to stop - Position I to lower.
2. Light switch: to switch on the internal lights.
4. Thermometer:
unit. to read the temperature inside the appliance.
a)
temperature setting. Press key
changed by pressing key 6 "UP"
8. CHECKING CORRECT OPERATION
Make sure that: 1
. the plug is connected;
3 . thermometer shows the desired temperature for the goods to be stored;
direct sunlight or to powerful lamps;
6
(climatic class 4); . there are no direct air draughts in the appliance, owing to the presence of doors,
windows, fans or conditioner outlets.
9. INTERNAL AND EVAPORATOR CLEANING
1.
Switch off the appliance. .Remove the refrigerated goods and place in a suitably refrigerated place.
3. Open the tap under the appliance.
5.
tools to remove the ice.
bicarbonate and dry with care.
10. REPLACEMENT OF THE LAMP
1. Open the cover. 2. Switch off the appliance
4
place. . Remove the lamp socket, whilst holding the fluorescent tube and its protective cover. . Pull the
protective cover out of the other lamp socket.
following the above instructions in reverse order (see fig. 6).
Operator's guide
a)
complies with the IEC regulations:- differential thermal-
c)
5
N.B.: if the equipment has been transported or stored overturned, let is
3. Refrigeration switch:
5 "SET or P"
once to display the temperature set-point, which can be
or 7 "DOWN" (see fig. 5).
2.
the refrigeration unit switch is on (green light lit up);
5.
ambient temperature does not exceed +30°C with 55% R.H.
2
4. Leave the appliance to defrost. Do not use sharp or pointed metal
Clean sides and accessories with a sponge dipped in water and a little sodium
. 3. Remove the screws securing one of the lamp sockets in
6. Replace the fluorescent tube.
7
is properly earthed; b) fulfils the requirements of the
to switch on the refrigeration
Thermostat:
4. appliance is not exposed to
7.
(A) attached
to adjust the
5
Refit all components by
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO