Selco RC 18 Instrucciones De Uso página 10

4 MAINTENANCE
Routine maintenance must be carried out on the
system according to the manufacturer's directions.
Any maintenance operation must be performed by qualified
personnel only.
No type of modification must be made to the system.
Disconnect the power supply before every opera-
tion!
Carry out the following periodic controls on the
power source:
- Check the electric connections and all the con-
nection cables.
Failure to perform said maintenance will invalidate all war-
ranties and exempt the manufacturer from all liability.
6 TECHNICAL SPECIFICATIONS
Power supply voltage
Maximum input power (W)
Input current
Dimensions (lxdxh)
Weight
Power supply cable
Manufacturing Standards
10
RC 18
15V
0.2W
15mA
160x160x50 mm
0,7 Kg.
6 m
EN 60974-1
EN 60974-10
5 DIAGNOSTICS AND SOLUTIONS
The repair or replacement of any parts in the
system must be carried out only by qualified
engineers.
The repair or replacement of any parts in the system by
personnel other than authorised personnel shall cause the
product warranty to become null and void.
The system must not be modified in any way.
The manufacturer declines any responsibility should the
operator not follow these instructions.
Incorrect power supply
Cause Faulty potentiometer/encoder for the adjustment
of the welding/cutting current.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
RC 180
15V
0.2W
15mA
160x160x50 mm
0,7 Kg.
6 m
EN 60974-1
EN 60974-10
RC 190
15V
0.2W
15mA
160x160x70 mm
0,7 Kg.
6 m
EN 60974-1
EN 60974-10