Rise VIGILANT 800/I Manual De Instalación página 19

Carefully read the instructions manual in all of its pars and keep it in a safe location for any future consultation.
Not following the standards and warnings included in the present manual or an incorrect installation may damage per-
-
This product has been designed and manufactured exclusively for the use indicated in this documentation. Any non-conforming
use may damage the product or be a source of danger for persons and/or property.
- Do not install the product in an explosive atmosphere: the presence of flammable gasses or vapours is a source a serious
danger.
- Installation must be completed in observance of current standards.
- For installation in countries outside of the EEC, besides national reference regulations, the above mentioned standards and
warnings must be obeyed in order to obtain a suitable level of safety.
- Verify that the system has been earthed according to Good Practice standards and the metal parts must be connected to it.
- For each system, a suitable sign is recommended.
- Do not stand in the movement area of the bollard.
- Do not leave packaging materials (plastic, polystyrene, wood ...) within reach of children because they may be a potential
source of danger.
- Do not allow children to play with the commands or in proximity of the bollard.
- In the case of functioning anomalies do not attempt to repair the fault but contact a specialised technician. Only use original
RISE Srl accessories.
- Do not modify any components that are part of the RISE system. Any modification, alterations or tampering with the RISE
system, or the use of non original RISE accessories, will cause the product warranty to lapse and RISE Srl declines any re-
sponsibility with regards to safety and proper system operation.
- The installer must provide the user with all information necessary for system use and maintenance along with manual and
emergency manoeuvres. He must deliver them and the user must request the booklet containing warnings and use and main-
tenance standards.
- The bollard must be completely lowered before transiting through the controlled passage area.
- Anything that is not specifically planned for in these instructions is not allowed.
In case of flooding or significant precipitation that causes obvious drainage problems, avoid using the bollard until normal
conditions have been restored.
In the event of a power cut or of malfunction the bollard can be unlocked with the emergency switch fitted close to the control
unit. Keep the switch pressed to lower the bollard.
Control units for 2/4 bollards are equipped with ABC clamps that raise or lower the bollard even in case of complete control unit
malfunction and without mains power supply.
- Replace the buffer battery in the control unit maximum every 2 years. Dispose of them in compliance with the Standards in
force.
- Absolutely avoid attempting to carry out repairs: you could cause accidents; for such operations call a specialised techni-
cian.
Maintenance to bollards, control units and the entire system must be completed exclusively by specialised technical personnel.
The RISE bollards do not require any special maintenance, periodically checking that the area around the bollard is suf-
ficiently clean and, as needed, the gaskets at the base of the bollard should be replaced. Programmed routine controls
of the entire system are recommended only in cases of intense product use in order to ensure correct operation and long
product life.
Check the state and efficiency of the control unit and UPS unit batteries at least once a year and, if necessary, have them
replaced. The batteries must be replaced at least once every two years. For other instructions regarding product mainte-
nance consult the technical manuals supplied with the bollards and control units.
If the bollard is withdrawn from service, the current laws and regulations in force concerning the separate waste disposal
and the recycling of the various components (metals, plastics, electric cables etc.) must be respected; it is advisable to
contact your installer or a specialised company, authorised for the purpose.
All RISE products are covered by an insurance policy that answers for any damage to things or persons caused by manu-
facturing defects.
User instructions - VIGILANT 800/I
SAFETY STANDARDS
ATTENTION:
sons or property.
ATTENTION: PRECAUTIONS FOR USE
MANUAL EMERGENCY MANOEUVRE
MAINTENANCE
DISPOSAL
ATTENTION
GB
VIGILANT - 19