Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Tools required for assembly (not included):
• tape measure
• electric drill with #2 drill bit (A)
• level
• (x 2) #8 x 2" screws (B)
• (x 2) wall anchors - if the vanity will not be screwed to wall studs (C)
Estimated installation time: 2-1/2 hours (including removal of old vanity if applicable)
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra precautionary
measures to ensure a secure grip on the vanity base when lifting.
CARE & MAINTENANCE
• To maintain the beauty of the furniture finish, avoid placing the vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base immediately with a clean, soft and dry cloth.
INSTALLATION
Model 30003 shown in illustration
1: Removing old vanity (if applicable): 1) Turn off the water supply and take the drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity. NOTE: If the new vanity is not installed immediately, temporarily stuff a rag into the drain pipe.
2: Using a level, locate any uneven floor and/or wall areas where your vanity will be installed. Unevenness can cause your vanity to
become misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.
3: 1) Place the vanity in the desired position taking into account the location of your plumbing. 2) Ensure the vanity is level front to back
and at both sides.
4: Secure the vanity to the wall by inserting (x 2) #8 x 2" screws (B - not included) through the back rail of the vanity. Figure 1. NOTE: It
is recommended that the vanity be installed to at least one wall stud. If you are unable to locate wall studs, it is recommended that you
use wall anchors (C - not included) to secure the vanity.
5: Install the hardware, vanity top, faucet and drain (each not included) as per the instruction sheets provided with those items and
ensure that there is no leakage.
TROUBLESHOOTING
Problem:
1) Vanity doors or drawers rub against
another surface.
2) There is an uneven gap between
the doors or drawers and cabinet.
Please send the images of the
sticker for replacement part
Figure 1
reference.
Possible Cause:
Floor or vanity is not level.
CAUTION:
The bathroom floor and wall must be finished prior to
installation of the vanity base.
Corrective Action:
1) Use a shim to ensure the vanity is
level.
2) Adjust the door hinges. Figure 2.
(Please do not
peel this sticker.
Replacement parts
can be arranged
only based on this
sticker reference.)
Publicidad
